Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 344: Misframe Alarm Inquiry Test (#145)
Error
Code
Test
Result
Description / Recommendation
ABORT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
2000 ABORT Response to the test was not received within the allowed time. This may
be due to hyperactivity.
1. Enter display errors
2. Check the Error Log for Error Type 1538. If Error Type 1538
appears in the error log for this board, see Hyperactive DS1/UDS1
Interface Circuit Pack/Media Module for the repair procedures.
Otherwise, retry the test at 1-minute intervals up to 5 times.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
ANY FAIL The DS1 board detected errors in the received framing bits pattern. The
Error Code value is the number of misframes detected since the last
misframe alarm inquiry test. Major bit and minor bit error rate (Error
Types 2561 and 2817) errors often accompany misframe alarms.
Clearing the cause of these errors may clear the misframes which are
occurring.
1. Enter list measurement ds1-log location to read the
error seconds measurement.
2. If the DS1/UDS1 circuit pack or media module connects to a T1
network facility or to another switch, see T1 Network Facility
Procedures
0 NO
BOARD
3. If the DS1/UDS1 circuit pack or media module connects to a
line-side terminating device such as a PRI terminal adapter, see
Line-side Terminating Device Procedures
PASS No Misframe Alarm is detected on the DS1 board.
See NO BOARD for the repair procedures
1256 Maintenance Alarms for Communication Manager, Media Gateways and Servers