Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Hyperactivity is often caused by the associated facility. In this case, faults such as slips,
misframes, or blue alarms would be entered in the error log. In addition, many hardware errors
would be logged against the associated trunk circuits.
If the facility is OK and the error occurs again after 15 minutes, escalate this problem.
Repair Procedures for DS1/UDS1
Circuit Pack/Media Module
T1 Network Facility Procedures
If the DS1/UDS1 circuit pack or Media Module connects to a T1 network facility or to another
switch, do the following:
1. Verify that both endpoints of the DS1 link are administered using the same signaling mode,
framing mode, and line coding.
2. Contact the T1 Network Service or a technician at the far-end switch to diagnose the
remote DS1 endpoint.
3. Check the physical connectivity of the DS1 boards and of the cable.
4. Replace the local DS1/UDS1 circuit pack or media module, and repeat the test.
Line-side Terminating Device Procedures
If the DS1/UDS1 circuit pack or media module connects to a line-side terminating device such
as a PRI terminal adapter, do the following.
1. Verify that the switch DS1 and the line-side terminating device are administered using the
same signaling mode, framing mode, and line coding.
2. Investigate the maintenance status of the line-side terminating device. Refer to the
'Line-Side Terminating Device Operating Manual' for information.
3. Contact the vendor of the line-side terminating device to diagnose the equipment.
4. Check the physical connection of the DS1 board to the terminating device, and check the
premise distribution system or the intra-premise wiring for physical connection failures.
5. Replace the local DS1/UDS1 Interface circuit pack or media module and repeat the test.
1726 Maintenance Alarms for Communication Manager, Media Gateways and Servers