Demand test descriptions and error codes - Avaya Support

Error log entries and recommended actions
S8700 series | S8500
Table 247: SYNC Error Log Entries
Error Type Aux
Data
Associated Test Alarm
Level
SYNC (Port Network Synchronization)
On/Off
Board
Recommended Action
0 (a) 0 Any Any Any test synchronization
1 (b)(i) WRN
MIN (g)
Notes:
a. Error Type 0: run the short test sequence first. If every test passes, run the long test
sequence. Refer to each test’s description, and follow its procedures.
b. Error Type 1: run the short test sequence first. If every test passes, run the long test
sequence. Refer to each test’s description, and follow its procedures.
This error indicates a problem with the primary DS1 reference. It is cleared when the
primary reference is restored. To find the problem’s source:
1. Enter list configuration board location to check if the primary DS1
Interface circuit pack is inserted in the carrier.
2. Verify that the administered primary reference matches the DS1 reference from the
network synchronization plan.
OFF
18 (c) 0 disable sync WRN OFF enable sync
257 (d)(i) WRN
MIN (i)(g)
513 (e)(i) WRN
MAJ (i)(g)
OFF
OFF
769 (f) MAJ OFF
1793 (g) 1
0–50 MAJ OFF
2049 (h) 0 WRN OFF
1. It can take up to 1 hour for these alarms to clear.
Issue 5 May 2009 917