Demand test descriptions and error codes - Avaya Support

p. Error Type 1313: CPE loopback jack deactivation error. This error occurs when the
TN767E circuit pack could not deactivate a CPE loopback jack loopback.
Attempt to clear the alarm with busyout board location, test ds1-loop
location end-loopback/span-test, and release board location. If the
attempt to deactivate the CPE loopback jack loopback continues to fail, other steps must
be taken to deactivate the loopback.
q. Error Type 1314: Far CSU Loopback deactivation error. This error occurs when the
TN767E circuit pack could not deactivate a far-end CSU loopback on power-up/reset or
upon software request.
Attempt to clear the alarm with busyout board location, test ds1-loop
location end-loopback/span-test, release board location. If the attempt to
deactivate the Far CSU loopback continues to fail, then escalate the problem.
r. Error Type 1538: The hyperactive circuit pack is out-of-service and may exhibit one or
more of the following symptoms:
● The common circuit pack-level tests, such as Test #51 and Test #220, are aborting
with Error Code 2000.
● The tests run on the ports of this circuit pack are returning NO BOARD.
● A busyout/release of the circuit pack has no affect on test results.
● List configuration shows that the circuit pack and ports are properly installed.
The circuit pack is isolated from the system and all trunks of this circuit pack are placed
into the out-of-service state. The system will try to restore the circuit pack within 15
minutes. When no faults are detected for 15 minutes, the DS1 Interface circuit pack is
restored to normal operation. All trunks of the DS1 Interface circuit pack are then returned
to the in-service state. If the error recurs after 15 minutes, then escalate this problem.
s. Error Type 3160: this board is receiving slips. The AUX Data displays the last Slip count
that was reported.
t. Error Type 3329 - 3345: this board is receiving misframes. The AUX Data displays the last
misframe count that was reported.
u. Error Type 3840: ignore. This error is not service-affecting.
v. Error Type 3900: gives status information about a CPE Loopback Jack test. The value in
the Aux Data field indicates the status of the loopback test:
Aux Data 1: Test is currently running.
Aux Data 2: Test failed because loopback could not be activated.
Aux Data 3: Test failed because test pattern could not be detected.
Aux Data 4: Test has been deactivated.
w. Error Type 3901: gives status information about a Far CSU Loopback test. The value in the
Aux Data field indicates the status of the loopback test.
Aux Data 1: Test is currently running.
Aux Data 2: Test failed because loopback could not be activated.
352 Maintenance Alarms for Communication Manager, Media Gateways and Servers