Demand test descriptions and error codes - Avaya Support

Table 536: Short IP 2-Way Transmission Test (#1505) 2 of 3
Error
Code
Short IP 2-Way Transmission Test (#1505)
1003 ABORT The system could not allocate a tone receiver for the test. The system
may be oversized for the number of Tone Detectors present, or some
Tone Detectors may be out of service.
1. Enter list measurements tone-receiver to see
information regarding the system’s tone receivers.
2. Resolve any TTR-LEV (TTR Level) errors.
3. Resolve any TONE-PT (Tone Generator) errors.
4. Retry the command at 1-minute intervals up to 5 times.
1014 ABORT Board not inserted.
1. Insert and administer a Media Processor circuit pack.
2000
2012
2100
2500
Test
Result
Description / Recommendation
ABORT Response to the test was not received in the allowed time.
System call failed. Internal system error.
Could not allocate the necessary system resources to run this test.
Internal system error.
1. Retry the command at 1-minute intervals up to 3 times.
2801 ABORT The IP Media Processor has not been administered on the
change ip-interface form.
1. Administer the IP Media Processor on the change
ip-interface form and rerun the test.
2806 ABORT The system could not find any in-service IP Media Processors to use as
a destination for this test.
2807 ABORT The specified IP Media Processor has been disabled on the
change ip-interfaces form.
1. Enable the IP Media Processor on the change ip-interfaces
form.
2 of 3
Issue 5 May 2009 1675