Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 433: Tie Trunk Seizure Test (#747) 3 of 3
Error
Code
Test
Result
1040 ABORT This test is not executed on trunk ports which are administered as
access endpoints.
1. Verify that this port is an access endpoint by entering
display port.
2. If the port has been administered as an access endpoint, this
test should abort and this error can be ignored.
2000 ABORT
or
FAIL
SNI Circuit Path Test (#755)
Seizure message is not received back within 10 seconds.
1. Retry the command at 1-minute intervals a maximum of 5
times.
2. If the test continues to fail, check the far-end to ensure a
translation match at both ends.
3. Check the facility.
2100 ABORT Could not allocate the necessary system resources to run the test.
1. Retry the command at 1-minute intervals up to 5 times.
3 FAIL No dial tone detected from the other end. (TN439 circuit packs only.)
1. Retry the command at one minute intervals up to five times.
2. If the test continues to fail, check the far-end PBX to ensure a
translation match at both ends.
3. Check the facility.
0 NO
BOARD
Description / Recommendation
PASS The relevant Seizure test passes. This port is functioning properly.
1. If users are reporting troubles, examine loop connections to
the port, wiring, and stations.
See NO BOARD for the repair procedures.
The SNI Circuit Path Test performs an on-board test of the circuit path. It runs on SNI-BD (SNI
Circuit Pack) and SNI-PEER (SNI Peer Link).
1444 Maintenance Alarms for Communication Manager, Media Gateways and Servers
3 of 3