Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 486: Far CSU Loopback Test (#1213) 2 of 3
Error
Code
Test
Result
Description / Recommendation
1015 ABORT Ports on the DS1 Interface circuit pack have not been busied out to
out-of-service.
1. Enter busyout board location to put all trunks or ports of the
DS1 Interface circuit pack into the out-of-service state.
2. Retry the command.
1039 ABORT The DS1 Interface circuit pack is providing timing for the system. Executing
this test could cause major system disruption.
If the DS1 Interface circuit pack needs to be tested, set the
synchronization reference to another DS1 Interface circuit pack or to the
Tone-Clock circuit with the following command sequence:
1. disable synchronization-switch.
2. set synchronization location.
3. enable synchronization-switch.
1950 ABORT Another loopback/span test is already executing on the DS1 board or the
board is in a network requested loopback mode (Line loopback or Payload
loopback). The error log will indicate whether a Customer Loopback Jack
test, Far CSU Loopback test, or the One-Way Span test is executing or if
the board is in line loopback or payload loopback mode. Only one
long-duration loopback/span test can be active at a given time.
If a loopback/span test is already active, that test must be deactivated with
test ds1-loop location end-loopback/span-test in order to
run this test.
2000 ABORT Response to the test was not received within the allowed time.
1. Check for board hyperactivity. See Hyperactive DS1/UDS1 Interface
Circuit Pack/Media Module.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
2 FAIL The far CSU Loopback test was not set up properly. The DS1 Interface
circuit pack could not put the far-end CSU into loopback mode.
1590 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 3