19.12.2012 Views

Demand test descriptions and error codes - Avaya Support

Demand test descriptions and error codes - Avaya Support

Demand test descriptions and error codes - Avaya Support

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

ATM-TRK (Circuit Emulation Service Circuit Pack)<br />

1. Check the connections between the fiber cable, the ATM-TRK circuit pack, <strong>and</strong> the<br />

ATM switch.<br />

2. See PKT-BUS (Packet Bus) for <strong>test</strong> <strong>and</strong> corrective procedures.<br />

3. Determine what type of fiber is installed between the ATM-TRK circuit pack <strong>and</strong> the<br />

ATM switch.<br />

If Then<br />

There is multimode fiber Check the length of the fiber. If the cable is<br />

longer than 2 km, it may be causing <strong>error</strong>s.<br />

There is single-mode fiber or the length of<br />

the multimode fiber is less than 2 km<br />

4. Perform ATM loopback <strong>test</strong>s on the near-end ATM-TRK circuit pack <strong>and</strong> on the far-end<br />

circuit pack or ATM switch.<br />

If Then<br />

The ATM-TRK circuit pack fails the<br />

loopback <strong>test</strong>.<br />

The far-end circuit pack or ATM switch<br />

fails the loopback <strong>test</strong>.<br />

The equipment at each end of the ATM<br />

span passes the loopback <strong>test</strong><br />

The source of the <strong>error</strong>s can lie in the ATM<br />

facility, the ATM-TRK circuit pack, or the far-end<br />

circuit pack.<br />

The problem is in the ATM-TRK circuit pack.<br />

Replace the circuit pack.<br />

5. Check capacity <strong>and</strong> peak b<strong>and</strong>width consumption for the ATM span.<br />

If Then<br />

The capacity of the span is inadequate, or<br />

b<strong>and</strong>width consumption is too high.<br />

The problem is in the far-end circuit pack or ATM<br />

switch. Consult the circuit-pack or ATM switch<br />

documentation for advice.<br />

The problem is somewhere in the ATM span. Lack<br />

of b<strong>and</strong>width can be forcing an intermediate ATM<br />

switch to drop cells.<br />

Reduce traffic on the system to ensure that it is<br />

using no more that its subscribed b<strong>and</strong>width.<br />

h. Error Type 771: the ATM switch is sending cells with unknown Virtual Path-Identifier (VPI)<br />

<strong>and</strong> Virtual Chel-Identifier (VCI) addresses.<br />

1. Make sure that the ATM-TRK circuit-pack address is administered identically on the<br />

ATM switch <strong>and</strong> the S8700-series system.<br />

i. Error Type 1281: Board major signals <strong>error</strong> (loss of high-level signal). The far end has<br />

detected a major problem in transmissions originating from the ATM-TRK circuit pack. The<br />

possible Aux Data values for this software counter are listed in Table 55: Error type 1281<br />

Aux Data <strong>and</strong> repair procedures on page 190.<br />

Issue 5 May 2009 189

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!