Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 288: Digital Line Electronic Power Feed Test (#11) 2 of 2
Error
Code
Test
Result
1000 ABORT System resources required to run this test are not available. The port
may be busy with a valid call.
1. Enter display port location to determine the station
extension or attendant number of the port.
2. Enter status station or status attendant to determine the
service state of the port. If the port is in use, wait until it is idle
before testing. Attendants are always in use (off-hook) if the
handset is plugged in and the port is not busied out.
3. If the port status is idle, then retry the command at 1-minute
intervals up to 5 times.
2100 ABORT Could not allocate the necessary system resources for this test.
1. Retry the command at 1-minute intervals up to 5 times.
FAIL Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
PASS Electronic Power Feed test passed. The message to turn on the power
to the station was successfully sent to the port.
1. Although, except for the previous Internal system error, this test
never actually returns a FAIL result, it will log an error indicating the
real results of the test. Check the Error Log for any entries with
Error Types 767 or 769 after the test completes.
2. If Error Type 767 appears in the Error Log, this indicates that the
test sensed no problems with the power to the station. To verify that
the station is powered up correctly, run a self-test on the station and
check that every feature button is operating.
3. If Error Type 769 appears in the Error Log, this indicates some
problem with the power to the station. Check for a short in the
wiring, a damaged jack, a defective voice terminal, or an incorrect
type of terminal.
0 NO
BOARD
Description / Recommendation
See NO BOARD for the repair procedures.
1106 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 2