Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 364: 140AY Looparound Test (#210) 3 of 3
Error
Code
Test
Result
Description/ Recommendation
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
ABORT Internal system error.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1-3 FAIL The test failed. The error code indicates at which speech compression
rate the test actually failed (one being the first rate tested, three being the
last).
1. Reset the circuit pack via reset board location and then run
this test again. If the test still fails, replace the circuit pack (see
Warning) and run this test again.
2. If there are recurring alarms on this circuit pack caused by this test
failing, replace the circuit pack even if Step 1 works (see Warning).
WARNING: Replacing
the circuit pack results in loss of integrated
announcements. See General notes.
PASS The record chel on the announcement circuit pack is functioning properly.
User-reported troubles on this circuit pack should be investigated using
other circuit pack and port tests. Refer to -PT (Announcement Port) for a
description of the tests.
Super Frame Match Inquiry Test (#211)
The super frame is a means by which the Speech Processor (SP) synchronizes with the 140AY
device on the announcement circuit pack. If the super frame is not synchronized, the SP is not
able to properly process record/playback requests. Both the SP and the hardware generate a
super frame pulse. When these two pulses are out of synch, the SP sets a flag to indicate the
mismatch. When this test is run, the state of this flag is returned.
1294 Maintenance Alarms for Communication Manager, Media Gateways and Servers
3 of 3