Demand test descriptions and error codes - Avaya Support

Table 457: Automatic Transmission Test (#844-848) 2 of 5
Error
Code
Test
Result
Description / Recommendation
Automatic Transmission Test (#844-848)
1002 ABORT The system could not allocate time slots for the test. The system may be
under heavy traffic conditions, or it may have time slots out-of-service
due to TDM-BUS errors. A system is considered under heavy traffic
when the Call Processing Occupancy is greater than 50% or when the
System Management and the Call Processing Occupancies together
exceed 65%.
1. Enter status health to view the occupancy measurements.
2. Enter display errors and resolve any TDM-BUS (TDM Bus)
errors.
3. If the system has no TDM-BUS errors and is not handling heavy
traffic, retry the command at 1-minute intervals up to 5 times.
1004 ABORT The port has been seized by a user for a valid call.
1. Enter status trunk to determine when the port is available for
testing.
2. Retry the command at 1-minute intervals up to 5 times.
1005 ABORT Wrong trunk group type for this test. This error can be ignored.
1115 ABORT The near end test line on the TN771 circuit pack could not be allocated.
1. Enter status port and verify that the TN771 circuit pack is in
service. Also verify that port 1 is administered and in service.
2. Retry the command at 1-minute intervals up to 5 times.
1900 ABORT Test completion message was not received from the TN771 circuit pack.
1. Test the TN771 circuit packs.
1901 ABORT TN771 sent wrong response for this test.
1. Verify that the trunk is administered properly.
2 of 5
Issue 5 May 2009 1521