Demand test descriptions and error codes - Avaya Support

BRI Set Audits Test (#630)
BRI Set Audits Test (#630)
This is a series of tests that are classified as audits. The switch sends messages to the BRI
endpoint to perform the following tests:
● Ringer Audit – This audit verifies that both the switch and the endpoint agree as to the
current state of the endpoint’s ringer.
● Lamps Audit – This audit verifies that both the switch and the endpoint agree as to the
current state of the endpoint’s lamps.
● Call Activity Audit – This audit verifies that the state of calls is consistent between the
switch and the endpoint.
This test is not executed for ASAI or Avaya adjunct because adjuncts do not employ ringers or
lamps and do not establish calls on the B-Chels associated with the BRI interface.
This test is run on BRI-SET, Various Adjuncts.
Table 425: BRI Set Audits Test (#630) 1 of 2
Error
Code
Test
Result
Description / Recommendation
1113 ABORT The signaling link between the switch and the endpoint is down.
1. Enter test port location long to clear any errors that prevent
establishment of the signaling link.
2. Examine the results of the Signaling Link Status test (#626) that is
run as part of this command. If this test aborts or fails, follow the
repair procedure for Signaling Link Status Test (#626).
3. If the BRI Set Audits test continues to abort, escalate the problem.
1139 ABORT The PN’s packet bus is out-of-service.
1. Follow the repair procedures for the packet bus.
2. After completing step 1, enter test port location long and
review the results of the BRI Port Local LAN Looparound Test (#618)
to verify the repair.
1144 ABRT The PPN’s packet bus is out-of-service.
1. Follow the repair procedures for the PPN’s packet bus.
2. After completing step 1, execute test port PCSSpp long, and
review the results of the BRI Port Local LAN Loop Around test (#618)
to verify the repair.
1 of 2
Issue 5 May 2009 1425