Demand test descriptions and error codes - Avaya Support

Table 403: Expansion Interface Packet Interface Test (#589) 3 of 5
Error
Code
Test
Result
Description / Recommendation
Expansion Interface Packet Interface Test (#589)
1141 ABORT The Packet Interface circuit pack is out of service.
1. See PKT-INT (Packet Interface) for the recommended repair
procedure.
1144 ABORT The PN’s packet bus has a major alarm against it. This test needs to use
the alarmed PN’s packet bus.
1. Enter display alarms and resolve any PKT-BUS alarms.
2. Retry the command.
1394 ABORT The EI circuit pack is out of service and the test cot be run. This condition
is due to a change in the EI circuit pack’s ability to communicate with the
EI or SNI circuit pack on the other end of the fiber.
1. Run Test #237 and check the Error Log for EXP-INTF Error Type
1281. If Error Type 1281 is present or if Test #237 does not pass,
see the repair procedures for Expansion Interface Neighbor Query
Test (#237).
2. If Test #237 passes, rest the EI pack. Note that this will not be
destructive to the port network where EI circuit pack resides
because it will not be serving as the expansion Archangel if it is not
in service.
3. Repeat this test.
1395 ABORT This test cot be run on an EI circuit pack if it is part of the B-side PNC and
duplicated PNC is not enabled.
1. If this test needs to run on this EI circuit pack, enter change
system-parameters duplication to enable PNC.
2. Enter set pnc lock to prevent the system from doing a PNC
interchange.
3. Repeat this test.
3 of 5
Issue 5 May 2009 1379