Demand test descriptions and error codes - Avaya Support

Table 491: Trunk-side Layer 1 Query Test (#1242) 2 of 3
Error
Code
2012
2100
Test
Result
Description / Recommendation
Trunk-side Layer 1 Query Test (#1242)
ABORT Internal system error.
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1 FAIL Received a status of Level 1 Pending Activation. U interface is down,
indicating a problem with a connection between the switch and the NT1,
a 2- to 4-wire converter that is used to connect 4-wire terminals to a
2-wire TN2198 or TN2185 circuit pack.
1. Verify that the connections between the switch and the NT1 are
good. Verify that the NT1 has power.
2. Enter test port location and review the results of the Level 1
Status Query Test #1242 to verify the repair. If this test still fails,
proceed to Step 3.
3. Follow the manufacturers repair procedures for the NT1. Then
enter test port location and review the results of the Level 1
Status Query test to verify repair.
2 FAIL Received a status of Level 1 Pending Activation. U interface up, S/T
interface down, which indicates a problem with the NT1 or the wiring
between the NT1 and the BRI endpoint (S/T interface).
1. Enter test port location and review the results of the Level 1
Status Query test to verify the repair. If this test still fails, proceed to
Step 2.
2. Follow the manufacturer-recommended repair procedures for the
NT1. Then enter test port location and review the results of
the Level 1 Status Query test to verify repair.
2 of 3
Issue 5 May 2009 1601