Demand test descriptions and error codes - Avaya Support

Note:
Note: Not all tests that run on circuit packs are applicable to media modules. These
tests will abort with error code 1412. This error can be ignored.
The DS1 tie trunk maintenance strategy covers logging DS1 tie trunk hardware errors, running
tests for trunk initialization, periodic and scheduled maintenance, demand tests, and alarm
escalation and resolution. Three different trunk service states are specified in DS1 tie trunk
maintenance:
Out-of-service The trunk is deactivated and cot be used for incoming
or outgoing calls.
In-service The trunk is activated and can be used for both
incoming and outgoing calls.
Disconnect
(ready-for-service)
If the DS1 Interface circuit pack or media module is out of service, every trunk on the DS1
Interface circuit pack or media module is placed into the out-of-service state and a Warning
alarm is raised.
Error log entries and recommended actions
Table 262: TIE-DS1 Error Log Entries 1 of 2
Error
Type
Aux
Data
The trunk is in an activated state but can only be used
for an incoming call.
Associated Test Alarm
Level
On/Off
Board
Recommended Action
0 (a) 0 Any Any Any test trunk grp#/mem#
1 (b) 57476
57477
57485
57487
15 (c) Any Port Audit and
Update (#36)
18 (d) 0 busyout trunk
grp#/mem#
19 (e) 0
WRN OFF release trunk grp#/mem# 1
130 (f) WRN ON test trunk grp#/mem#
257 (g) 57473
57474
974 Maintenance Alarms for Communication Manager, Media Gateways and Servers
1 of 2