Demand test descriptions and error codes - Avaya Support

ADX16A-P (AUDIX Analog Line/Control Link)
CAUTION: Never
MO Name in
Log
Alarm
Level
ADX16A-P (AUDIX Analog Line/Control Link)
Initial Command to Run Full Name of MO
ADX16A-P MIN test port location l AUDIX Analog Line/ Control Link
WRN test port location
! CAUTION:
do any of the following without first shutting down AUDIX. Follow the
instructions on the TN566/TN2169 faceplate:
● Remove EMBEDDED AUDIX circuit packs
● Cycle power to a carrier containing EMBEDDED AUDIX circuit packs
● Remove power to a carrier containing EMBEDDED AUDIX circuit packs
The ADX16A-P MO represents a port on a TN566/TN2169 EMBEDDED AUDIX circuit pack that
is operating in control-link (CL) mode.
For circuit-pack-level problems (ADX16A-B or ANL-16-B), see XXX-BD (Common Port Circuit
Pack/Media Module).
For port-level problems with AUDIX operating in digital-port mode, see:
● ADX8D-PT (AUDIX Digital Port)
● ADX16D-P (16-Port AUDIX Digital Port)
The tests apply only to switch-side maintenance that tests a circuit pack’s components related
to the TDM-bus interface. The AUDIX system has an extensive maintenance strategy that is
described in DEFINITY® AUDIX Maintenance, 585-300-110.
AUDIX resides on a combined pair of circuit packs: the TN566 Multifunction board (MFB) and
the TN2169 Alarm board (ALB). The 2 boards occupy 5 slots, but only 1 slot is functional as far
as the switch is concerned. The other 4 slots are seen by the switch as “AUDIX-reserved” slots.
In CL mode, the TN566 pack supports up to 16 voice ports. When a call to a station with an
AUDIX login is not answered, AUDIX answers the call using one of the available voice ports.
Unlike other AUDIX systems, EMBEDDED AUDIX is not an adjunct.
Issue 5 May 2009 59