Demand test descriptions and error codes - Avaya Support

This test runs on the following maintenance objects:
● TDM-CLK (TDM Bus Clock)
● TONE-BD (Tone-Clock Circuit Pack)
● TONE-PT (Tone Generator)
Table 348: TDM Bus Clock PPM Inquiry Test (#150) 1 of 2
Error
Code
Test
Result
Description / Recommendation
TDM Bus Clock PPM Inquiry Test (#150)
ABORT The system could not allocate the necessary resources for the test
1. Wait 1-minute, then retry the test.
1001 ABORT The system could not allocate the necessary resources for the test.
1. Wait 1-minute, then retry the test.
255 ABORT The test was not executed because the IPSI or Processor/Tone-Clock
circuit pack was using its local oscillator rather than synchronizing to an
external source.
1. Verify that this IPSI or Processor/Tone-Clock circuit pack is
expected to be the synchronization source. If not, correct the
synchronization information and re-run the test.
1412 ABORT This test does not run on media modules or media gateways. Ignore
2000 ABORT Response to the test was not received within the allowed time.
1. Retry the command at 1-minute intervals up to 5 times.
2100 System resources required to run this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
Any FAIL The Error Code represents the rate (in Parts Per Million, or PPM) at
which clock slip errors have been detected on the incoming
synchronization source since the last PPM inquiry was sent to the IPSI
or Processor/Tone-Clock circuit pack. A failure of this test indicates that
we are outside of (S8700-series Fiber-PNC: Stratum-3) or Stratum-4 timing
specifications on the incoming timing source.
The Error Code is a variable amount ranging from 1 to 254.
1. If error 1537 is entered in the error log against TDM-CLK, then the
board has switched timing sources. Follow the procedures
associated with hardware log Error Code 1537.
2. Otherwise, see Troubleshooting Approach in SYNC (Port Network
Synchronization).
1 of 2
Issue 5 May 2009 1263