Demand test descriptions and error codes - Avaya Support

Table 285: NPE Crosstalk Test (#6) 4 of 8
Error
Code
1000
(cont’d)
Test
Result
Description / Recommendation
NPE Crosstalk Test (#6)
ABORT PE-BCHL:
1. Enter status pri-endpoint extension to determine the service
state of the port. If the port is in use, wait until it is idle.
2. Retry the command at 1-minute intervals up to 5 times.
WAE-PORT:
1. Enter status access-endpoint extension to determine the
service state of the port. If the port is in use, wait until it is idle.
2. Retry the command at 1-minute intervals up to 5 times.
All other Maintenance Objects:
1. Enter display port location to determine the station’s extension.
2. Enter status station extension to determine the service state of
the port. If the port is in use, wait until it is idle.
3. Retry the command at 1-minute intervals up to 5 times.
1001 ABORT System resources required to run this test are unavailable.
1. Retry the command at 1-minute intervals up to 5 times.
1002 ABORT The system could not allocate time slots for the test. The system may be
under heavy traffic conditions, or it may have time slots out-of-service due to
TDM-BUS errors. A system is considered under heavy traffic when the Call
Processing Occupancy is greater than 50% or when the System Management
and the Call Processing Occupancies together exceed 65%.
1. Enter status health to view the occupancy measurements.
2. Enter display errors and resolve any TDM-BUS (TDM Bus) errors.
3. If the system has no TDM-BUS errors and is not handling heavy traffic,
retry the command at 1-minute intervals up to 5 times.
4 of 8
Issue 5 May 2009 1087