Demand test descriptions and error codes - Avaya Support

Table 391: DS1 OPS Switchhook Inquiry Test (#312) 3 of 3
Error
Code
2012
2100
Test
Result
DS1 CO Trunk Dial Tone Seizure Test (#314)
DS1 CO Trunk Dial Tone Seizure Test (#314)
ABORT The test was aborted due to a system error.
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1 FAIL Internal system error.
1. Look for DS1-BD and UDS1-BD errors in the Error Log. If there
errors are present, see DS1-BD (DS1 Interface Circuit Pack) and/
or UDS1-BD (UDS1 Interface Circuit Pack).
2. If a chel multiplexer is used as the remote DS1 endpoint to which
the station connects, refer to the multiplexer vendor’s
maintenance document for diagnosis.
3. Retry the command at 1-minute intervals up to 5 times.
PASS The station hook states in both switch software and DS1 Interface circuit
pack are consistent.
0 NO
BOARD
Description / Recommendation
See NO BOARD for the recommended procedures.
3 of 3
This test checks the trunk’s signaling capability provided by the DS1 Interface circuit pack. The
test sends a “seizure” message to the DS1 Interface circuit pack and expects an “active” reply in
return. The test passes if the “active” message is received. It aborts if no message is received. It
fails if the DS1 Interface circuit pack returns a “reorder” message.
This test cot be run on a trunk in any of the following conditions:
1. The trunk direction is administered as an incoming only trunk.
2. The trunk has been seized by a normal trunk call.
3. The trunk is administered with maintenance test disabled.
4. The trunk is on a port of a DS1 Media Module.
This test runs on the following maintenance objects:
● CO-DS1 (DS1 CO Trunk)
Issue 5 May 2009 1353