Demand test descriptions and error codes - Avaya Support

Note: Failure
Note:
of this test will put the SIG-GRP in the OOS state.
Table 526: C-LAN Ethernet Status Test (#1386) 1 of 2
Error
Code
Test
Result
Description/Recommendation
1005 ABORT Ethernet Link is not in service.
C-LAN Ethernet Port Status Test (#1386)
The object is not in the right configuration to run this test. Either the
Compact Flash has not been turned on in the change media gateway form,
or the announcements have not been enabled, or the media gateway link is
down.
2000 ABORT Response to the test was not received from the MG announcement media
module within the allowable time period.
If this result occurs repeatedly, there is not much that can be physically
done as this module is a part of the mother board.
2012 ABORT The System Call failed. The command can be tried again. However, any
continuous failure with this error code should be escalated.
2100 ABORT The system resources to run the test could not be allocated.
Retry the command at 1-minute intervals up to 5 times.
2500 ABORT Internal system error.
Retry the command at 1-minute intervals up to 3 times.
1 FAIL The media gateway announcement module is experiencing problems with
the Compact Flash. The Compact Flash is either not inserted, or is
unrecognizable.
2 FAIL The media gateway announcement module is experiencing problems with
the Compact Flash. The Compact Flash does not have enough memory to
support the announcements on the MG announcement module.
4 FAIL The media gateway announcement module is experiencing problems with
the Compact Flash. The available RAM is not sufficient to support the
Compact Flash.
3, 5,
6, 7
The media gateway announcement module is experiencing problems with
the Compact Flash. Any of the errors—3, 5, 6 and, 7—indicates multiple
errors related to the Compact Flash.
For example, 3 is a combination of failures 1 and 2.
1 of 2
Issue 5 May 2009 1659