Demand test descriptions and error codes - Avaya Support

Expansion Interface Control Chel Test (#316)
If the circuit pack is a standby ATM-EI or EI (amber LED off), this test queries the circuit pack for
its type and vintage information. This test runs on ATM-EI (Expansion Interface Circuit Pack)
and EXP-INTF (Expansion Interface Circuit Pack).
Table 393: Expansion Interface Control Chel Test (#316) 1 of 2
Error
Code
Test
Result
Description / Recommendation
1030 ABORT The test is not being executed on the active PE in a duplex system.
1335 ABORT The PKTINT is on the standby SPE
2000 ABORT Response to the test was not received within the allowed time.
1. Retry the command at 1-minute intervals up to 3 times.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 3 times.
2500 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 3 times.
FAIL The ATM circuit pack responded incorrectly, or a PN’s active ATM-EI or
EI circuit pack could not communicate with the PN’s circuit packs.
1. If the PN’s active ATM-EI or EI circuit pack is failing and duplicated
PNC is enabled:
a. Enter reset PNC interchange to switch to the standby
PNC.
b. Repeat the short test sequence.
c. If test continues to fail, enter reset board location to
reset the circuit pack.
2. If the PN’s unduplicated ATM-EI or EI circuit pack is failing:
a. Enter display errors and display alarms, and follow
the associated repair procedures for TDM-CLK (TDM Bus
Clock), TONE-BD (Tone-Clock Circuit Pack), or SYNC (Port
Network Synchronization) alarms/errors.
b. Repeat the short test sequence.
c. If test continues to fail, replace the circuit pack or transceiver.
1 of 2
Issue 5 May 2009 1357