Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Sanity Test (#1547)
This test performs an IPSI maintenance board sanity handshake for CAB-MTCE (Media
Gateway Maintenance).
.
Table 552: Sanity Test (#1547)
Error
Code
Test
Result
Description and recommendation
1000 ABORT Internal system error.
1. Repeat the command at one-minute intervals up to 3 times.
1981 ABORT The TN2312BP IPSI is busied out.
1. Enter release ipserver-interface.
1982 ABORT The board being tested is NOT a TN2312BP IPSI or later.
1. Insert a TN2312BP IPSI circuit pack.
2033
2500
ABORT Internal system error.
Internal operation failed. Possible unknown cabinet type.
1. Repeat the command at one-minute intervals up to 3 times.
FAIL The TN2312BP in carrier A is missing. This test will also fail if an
incorrect response or no response from firmware is received when the
board is queried.
PASS The correct board is present and a valid response was received.
Environmental Maintenance Initialization Test (#1548)
The Environmental Maintenance Initialization Test is executed when an IPSI circuit pack is
inserted and the board and media gateway type is determined. When a TN2312AP is inserted in
a CMC1, G600, or G650, the Power Fan Lead (AuxSig) environmental maintenance is enabled.
When a TN2312BP IPSI is inserted in either a CMC1 or G600, Communication Manager sends
the following messages to the embedded software (firmware) on the board:
● Enable environmental maintenance (Power Fan lead)
● A query to verify that environmental maintenance is enabled
1710 Maintenance Alarms for Communication Manager, Media Gateways and Servers