Demand test descriptions and error codes - Avaya Support

Table 302: NPE Audit Test (#50) 2 of 2
Error
Code
Test
Result
Ringing Application Test (#51)
Ringing Application Test (#51)
1019 ABORT A test was already running on the port.
1. Retry the command at 1-minute intervals up to 5 times.
1412 ABORT This test does not run on media modules or media gateways. Ignore.
2030 ABORT EPN is down.
FAIL Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
PASS The circuit pack’s SCOTCH-NPE chip has been updated.
NO
BOARD
EXTRA
BD
Description / Recommendation
See NO BOARD for the repair procedures.
Certain circuit packs have limitations on how many circuit packs can be in
the system or port network such as the Maintenance/Test circuit pack
(TN771B or TN771C), the Tone Detector circuit pack (TN748B, TN748C or
TN748D) and the Call Classifier (TN744). The Maintenance/Test circuit
pack allows only one circuit pack per port network. The Tone Detector and
Call Classifier allow only 10 circuit packs in each system. All additional
circuit packs will return EXTRA-BD and should be removed.
The Ringing Application Test checks the ringing application circuitry common to every port on
an Analog Line circuit pack. This test runs on the following maintenance objects:
● MG-ANA (Analog Media Module)
● MG-IAMM (Integrated Analog Media Module)
2 of 2
Issue 5 May 2009 1155