Demand test descriptions and error codes - Avaya Support

Primary Signaling Link Hardware Check (#636)
Primary Signaling Link Hardware Check (#636)
This test runs on ATM-SGRP (ATM Signaling Group) and ISDN-SGR (ISDN-PRI Signaling
Group).
For ATM-SGRP, the ATM-SGRP Signaling Group D-chel port depends on the health of the
TN230X interface circuit pack on which it resides. This test fails if there are problems with either
the ATM-DCH (D-chel port) MO or the TN230X circuit pack. Investigate the ATM TN230X circuit
pack ATM-TRK (Circuit Emulation Service Circuit Pack) anytime there are problems with the
ATM D-chel port ATM-DCH (ATM D-Chel Port).
For ISDN-SGR, the ISDN-PRI Signaling Group D-chel port depends on the health of the TN464
UDS1 Interface circuit pack or DS1 Interface Media Module on which it resides. This test will fail
if there are problems with either the ISDN-PRI Primary D-chel port or the UDS1 circuit pack or
DS1 Media Module. If there are problems with the ISDN-PLK (ISDN-PRI Signaling Link Port),
also investigate UDS1-BD (UDS1 Interface Circuit Pack) or MG-DS1 (DS1 Interface Media
Module).
Table 426: Primary Signaling Link Hardware Check (#636) 1 of 2
Error
Code
Test
Result
Description / Recommendation
ABORT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
1700 ABORT Rollabout video abort. The PRI terminal adapter associated with the
primary D-chel port is detached from the circuit pack or media module.
This is a normal abort when the rollabout video feature is enabled. To
complete test on this port, either:
1. Re-attach the disconnected PRI terminal adapter, or
2. Enter change ds1 location to disable rollabout video on the
board, and set the Alarm when PRI Endpoint Detached field to y.
1 of 2
Issue 5 May 2009 1427