Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 358: Digital Looparound Test (#171) 3 of 4
Error
Code
Test
Result
Description / Recommendation
2000 ABORT Response to the test was not received within the allowed time.
1. Retry the command at 1-minute intervals up to 5 times.
2. Escalate the problem if the test continues to abort.
2003 ABORT Failed to receive an off-hook from the Data Line.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2004 ABORT Off-hook was not received from the data line device.
1. Busyout the digital port being tested on the data line circuit pack.
Retry the command at 1-minute intervals up to 5 times.
2. If the test still aborts, replace the circuit pack.
2005 ABORT The handshake between the Maintenance/Test circuit pack digital port
and the data line port failed.
1. Resolve any M/T-DIG (Maintenance/Test Digital Port) errors.
2. Retry the command at 1-minute intervals up to 5 times.
3. If the test still aborts, replace the data line circuit pack.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2312 ABORT The test did not receive loopback data.
1. Resolve any M/T-DIG (Maintenance/Test Digital Port) errors.
2. Retry the test, if still aborts, replace the Data Line circuit pack.
2313 ABORT Failed to receive a response from the Maintenance/Test digital port.
1. Resolve any M/T-DIG (Maintenance/Test Digital Port) errors.
2. Retry the command at 1-minute intervals up to 5 times.
3. If the test continues to abort, replace the Maintenance/Test circuit
pack.
2314 ABORT Data line port did not respond to the downlink message.
1. Busyout the digital port being tested on the data line circuit pack.
2. Retry the command at 1-minute intervals up to 5 times.
3. If the test still aborts, replace the circuit pack.
1278 Maintenance Alarms for Communication Manager, Media Gateways and Servers
3 of 4