Demand test descriptions and error codes - Avaya Support

Table 499: ATM Board Framer Looparound Test (#1260) 5 of 5
Error
Code
Test
Result
ATM Board Framer Looparound Test (#1260)
3 FAIL The test tone was transmitted correctly, but the returned tone was
distorted.
1. Test the active Tone-Clock in the PN, and verify that a tone is
reaching the ATM circuit pack. If not, see TONE-BD (Tone-Clock
Circuit Pack) for repair procedures.
2. If the Tone-Clock is healthy, test the ATM circuit pack using
test board location long.
3. If this test continues to fail, replace the ATM circuit pack.
4. Test the new ATM circuit pack with test board location long.
4 FAIL Unable to create loop for TDM path.
1. Retry the command at 1-minute intervals up to 3 times.
2. If this test continues to fail, replace the ATM circuit pack.
3. Test the new ATM circuit pack with test board location long.
5 FAIL Unable to create loop for packet path.
1. Retry the command at 1-minute intervals up to 3 times.
2. If this test continues to fail, replace the ATM circuit pack.
3. Test the new ATM circuit pack with test board location long.
6 FAIL A previously-established looparound was not released.
1. Enter reset board location.
2. Retry the command at 1-minute intervals up to 3 times.
3. If this test continues to fail, replace the ATM circuit pack.
4. Test the new ATM circuit pack with test board location long.
0 NO
BOARD
Description / Recommendation
PASS The ATM board is functioning properly,. However, this test does not verify
that the optical portion of the lightwave transceiver is functioning.
See NO BOARD for the repair procedures.
5 of 5
Issue 5 May 2009 1617