Demand test descriptions and error codes - Avaya Support

Table 273: UDS1-BD Error Log Entries 5 of 5
Error
Type
Aux
Data
3999 (af) Any None
Associated Test Alarm
Level
On/Off
Board
1. Run the short test sequence first. If every test passes, run the long test sequence. Refer to the appropriate
test’s description, and follow its recommended procedures.
2. If ports are assigned to the circuit pack, then a minor alarm is raised. If no ports are assigned to the circuit
pack, then a warning alarm is raised. The alarm is raised after the circuit pack has been missing for a period
of 15 minutes. Warning alarms are also raised against any ports administered on the circuit pack.
3. Minor alarms on this MO may be downgraded to Warning based on values on the set options screen.
4. Major alarms on this MO may be downgraded to minor or warning alarms based on values set on the set
options screen.
Notes:
a. Error Type 1: indicates that the circuit pack has stopped functioning or is not fully
administered. The alarm is logged about 15 minutes after the circuit pack has been
removed or 11 minutes after the SAKI test (#53) fails.
To be fully administered, a UDS1 circuit pack must meet all of the following conditions:
● Have an entry in the circuit plan using change circuit-pack
● Be administered using add ds1 location
Recommended Action
● Be physically inserted into the correct slot
If the circuit pack has an entry in the circuit plan and either of the other conditions are not
met, a MINOR alarm is logged. To resolve the error:
1. Make sure that all conditions for administration are met and that a functioning UDS1
circuit pack is inserted in the correct slot.
or
2. Completely remove the UDS1-BD from the system:
a. Remove any administered DS1 trunks, access endpoints or PRI endpoints
associated with the circuit pack from their trunk groups.
b. Execute remove ds1 location and change circuit-pack location.
If every administration condition is met for this circuit pack and the red LED is still on,
follow the instructions for LED alarms without Alarm Log entry or with Error Type 1 in LED
Descriptions for Avaya Aura Communication Manager Hardware Components
(03-602804)
b. Error Type 18: the UDS1 Interface circuit pack was busied out by busyout board
location.
1032 Maintenance Alarms for Communication Manager, Media Gateways and Servers
5 of 5