Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 467: PN Warm Restart Test (#956) 2 of 2
Error
Code
Test
Result
Description / Recommendation
FAIL Internal system error
1. Retry the reset command at 1-minute intervals up to 3 times.
PASS The PN Warm Restart procedure completed successfully.
Analog Port Sanity Test (#963)
This test verifies that the port circuitry involved in the analog trunk testing on the Maintenance/
Test analog port is functioning properly.
This test will abort if an ATMS test call is in progress on the Maintenance/Test analog port when
the test is requested.
This test runs on M/T-ANL (Maintenance/Test Analog Port).
Table 468: Analog Port Sanity Test (#963)
Error
Code
2000
2100
2500
Test
Result
Description / Recommendation
ABORT Response to the test was not received within the allowed time.
System resources required to run this test are not available.
An internal operation failed. The test could not be completed.
1. Retry the command at 1-minute intervals up to 5 times.
50 FAIL The switch was unable to communicate with the port circuitry used for
analog trunk testing.
1. Reset the circuit pack.
2. Test the port again using test port location l.
3. If the test fails again, replace the circuit pack.
PASS The Maintenance/Test analog port analog trunk testing capability is
operating correctly.
1546 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 2