Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 454: Far-End Internal Loopback Test (#797) 2 of 3
Error
Code
Test
Result
Description / Recommendation
2100 ABORT Could not allocate the necessary system resources to run this test
1. Retry the command at 1-minute intervals up to 3 times.
2300 ABORT The downlink message necessary to run this test could not be sent.
1. Retry the command at 1-minute intervals up to 3 times.
2301 ABORT The timer could not be set before sending the downlink message.
1. Retry the command at 1-minute intervals up to 3 times.
2316 ABORT Fiber link is not administered.
1. Enter add fiber-link to administer the DS1 converter.
2321 ABORT DS1 facility is not busied out.
1. Enter busyout ds1-facility to busyout the DS1 facility.
2. If there is only one DS1 facility, use busyout board to busyout
the DS1 converter circuit pack.
2332 ABORT For this system configuration, the test cot run at the far end when there is
only one DS1 facility available.
1. Run the test at the other end of the DS1 converter complex.
2500 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 3 times.
1514 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 3