Demand test descriptions and error codes - Avaya Support

RC NPE Allocation Test (#1336)
RC NPE Allocation Test (#1336)
This tests runs an RC NPE Allocation Test on a given RC. This test is run on RC-BD (Radio
Controller Board).
Table 514: RC NPE Allocation Test (#1336)
Error
Code
Test
Result
RC Tone Loopback Test (#1343)
This test is very disruptive.
Description / Recommendation
2000 ABORT No response to the test from the RC circuit pack. The circuit pack may
be busied out.
1. Enter release board loc. Retry the command at 1-minute
intervals up to 5 times.
2. If the test continues to abort, escalate the problem.
2012 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABORT Could not allocate the necessary resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort, escalate the problem.
ANY NO
BOARD
UTAM disablement of radio transmission usually causes this problem.
1. Check the Radio Transmission option. This option can be
changed only at the INADS or higher level.
2. Verify the system is not booting.
3. Enter display radio-controller loc and verify that the
RC is administered.
4. Retry the command at 1-minute intervals up to 5 times.
5. If the test continues to abort, escalate the problem.
PASS The RC board is functioning normally.
Issue 5 May 2009 1643