Demand test descriptions and error codes - Avaya Support

Modem Pool Conversion Resource Looparound Test (#98)
Table 321: Modem Pool Conversion Resource Looparound Test (#98) 2 of 5
Error
Code
Test
Result
Description / Recommendation
1340 ABORT No Maintenance/Test digital port is currently available for this test.
1. Enter list config and check if the Maintenance/Test digital
ports (ports 02 and 03) are present in the system. If the ports are
displayed, proceed to step 2. Otherwise, see M/T-PKT
(Maintenance/Test Packet Bus Port) and M/T-DIG (Maintenance/
Test Digital Port) to determine why no ports appear in the list
config display.
2. Look for M/T-DIG errors in the error log. If present, refer to M/T-DIG
(Maintenance/Test Digital Port).
3. If the ports are present and no errors are logged against them, retry
the command at 1-minute intervals up to 5 times.
4. If the test continues to abort, replace the Maintenance/Test circuit
pack.
5. If the test continues to abort after replacement, escalate the
problem.
2004 ABORT Off-hook was not received from the Pooled Modem.
1. Busyout the digital port being tested on the Pooled Modem circuit
pack.
2. Retry the command at 1-minute intervals up to 5 times.
3. If the test still aborts, replace the circuit pack.
4. If the test continues to abort after replacement, escalate the
problem.
2005 ABORT The Maintenance/Test and the Pooled Modem boards’ digital ports failed
to handshake.
1. Look for M/T-DIG errors in the error log. If any are present, refer to
M/T-DIG (Maintenance/Test Digital Port)
2. If no errors are present retry the command at 1-minute intervals up
to 5 times.
3. If the test still aborts, replace the Pooled Modem circuit pack.
4. If the test continues to abort after replacement, escalate the
problem.
2 of 5
Issue 5 May 2009 1197