Demand test descriptions and error codes - Avaya Support

Table 445: Failure Audit Test (#777) 2 of 3
Error
Code
Test
Result
Description / Recommendation
Failure Audit (#777)
2306 ABORT An SNI circuit pack on the fiber link is not responding to test requests
sent by software.
1. Run test led switch-node for the switch node(s) where the
SNI(s) reside to verify whether the LEDs on the board(s) light.
Follow the steps below for the SNI(s) from step 1 that had no LEDs
light.
2. If the LEDs on the other boards in the carrier light, but the LEDs on
this board do not light, run test 760 using test board location
long for the active SNC in this carrier. Wait 5 minutes, then try
step 1 one more time. If the LEDs on this board still do not light,
replace this board. Replacing an SNI may be service interrupting.
Refer to the documentation for SNI-BD (SNI Circuit Pack) for the
procedure to replace an SNI.
a. If none of the LEDs light for the boards in the same carrier as
this board, fix any problems associated with the connectivity of
this carrier to the server. Enter list fiber-link to
determine the fiber connections to this carrier. Check the LEDs
on every SNI and EI, and fix any fiber problems. Enter
display errors and resolve any EXP-INTF (Expansion
Interface Circuit Pack) error entries associated with the Port
Network. Also, Follow the repair procedures if there are errors
for any of the following:
● SYNC (Port Network Synchronization)
● SNI-BD (SNI Circuit Pack)
● SNC-BD (Switch Node Clock Circuit Pack)
● FIBER-LK (Fiber Link)
● SNI-PEER (SNI Peer Link)
2 of 3
Issue 5 May 2009 1491