Demand test descriptions and error codes - Avaya Support

Table 359: Data Module Internal Looparound Test (#175) 2 of 4
Error
Code
Test
Result
Description / Recommendation
Data Module Internal Looparound Test (#175)
1005 ABORT Looparound testing is not enabled on the data module administration
screen.
1. Set Looparound Test field to y on the data module administration
screen.
2. Retry the test.
1340 ABORT No Maintenance/Test digital port is currently available to perform this test.
1. Enter list config to determine whether the Maintenance/Test
digital ports 02 and 03 are present in the system. Because at least
one Maintenance/Test circuit pack must always be present in the PN
of S8700 configurations, there should be at least two such ports
present. If the ports are present, proceed to step 2. Otherwise,
determine why no ports appear in the list config display. See
M/T-DIG (Maintenance/Test Digital Port) and M/T-BD (Maintenance/
Test Circuit Pack).
2. Look for M/T-DIG errors in the Error Log. If present, see M/T-DIG
(Maintenance/Test Digital Port).
3. If the ports are present and no errors are logged against them, retry
the command at 1-minute intervals up to 5 times.
4. If the test continues to abort, replace the Maintenance/Test circuit
pack.
1341 ABORT No time-slots available to connect digital ports for the test.
1. Try the command again at 1-minute intervals up to 5 times.
1342 ABORT Connection failed.
1. Try the command again at 1-minute intervals up to 5 times.
1392 ABORT This port is a TTI port. The test does not run on TTI ports.
1. Verify that the port is a TTI port using display port where the
display shows that the port is a TTI port, or list config, where
the display shows a t for the port.
2. If list config or display port indicate that the port is not a
TTI port, escalate the problem. If both commands indicate that the
port is a TTI port, no action is necessary.
2 of 4
Issue 5 May 2009 1281