Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
BRI XID Test (#628)
This test checks the D-chel connection between the server and an endpoint or adjunct.
A D-chel XID frame is sent to the endpoint or adjunct over the point-to-point signaling link. The
test passes if the endpoint or adjunct responds with a layer-2 XID-RESPONSE frame.
This test must be administered to not run on the Station Administration screen for ports on a
TN2208.
This test runs on BRI-SET, Various Adjuncts.
Table 423: BRI XID Test (#628) 1 of 4
Error
Code
Test
Result
Description / Recommendation
1000 ABORT The BRI-SET, ASAI-ADJ, ATT-ADJ, LGATE-AJ, ATTE-AJ is busy. The
test cot be executed at this time:
1. Wait 1 minute and rerun the command.
2. If this problem persists, escalate this problem.
Note: A BRI-PORT can also be busy. When running this test for
BRI-PORT or ABRI-PORT, the above maintenance objects can be
changed to “BRI-PORT, ABRI-PORT, ATT-ADJ.”
1005 ABORT The endpoint is not administered to support XID testing.
1. If the endpoint documentation reflects support XID testing, enter
change station extension and change the XID Testing field
on the screen to y.
1113 ABORT The signaling link between the switch and the endpoint is down.
1. Enter test port location long to clear any errors that
prevent establishment of the signaling link.
2. Examine the results of the Signaling Link Status test (#626) that is
run as part of this command. If this test aborts or fails, follow the
repair procedure for Test #626.
3. If the XID test (#628) continues to abort, escalate the problem.
1418 Maintenance Alarms for Communication Manager, Media Gateways and Servers
1 of 4