Demand test descriptions and error codes - Avaya Support

Table 477: TSI Looparound Test (#1108) 2 of 2
Error
Code
Test
Result
Description / Recommendation
TSI Looparound Test (#1108)
1002 ABORT The system could not allocate time slots for the test. The system may be
under heavy traffic conditions, or it may have time slots out-of-service due
to TDM-BUS errors. A system is considered under heavy traffic when the
Call Processing Occupancy is greater than 50% or when the System
Management and the Call Processing Occupancies together exceed 65%.
1. Enter status health to view the occupancy measurements.
2. Enter display errors and resolve any TDM-BUS (TDM Bus)
errors.
3. If the system has no TDM-BUS errors and is not handling heavy
traffic, retry the command at 1-minute intervals up to 5 times.
1003 ABORT The system could not allocate a tone receiver for the test. The system may
be oversized for the number of Tone Detectors present, or some Tone
Detectors may be out of service.
1. Enter list measurements tone-receiver to see information
regarding the system’s tone receivers.
2. Resolve any TTR-LEV (TTR Level) errors.
3. Resolve any TONE-PT (Tone Generator) errors.
4. Retry the command at 1-minute intervals up to 5 times.
2000 ABORT Response to the test was not received within the allowed time.
1. If this result occurs repeatedly, attempt to reset the circuit pack if the
other ports are idle.
2. Rerun the test. If this result occurs again, replace the circuit pack.
2012 ABORT Internal system error. This is an abnormal abort.
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABORT Could not allocate the necessary resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
FAIL The TSI was found to be transmitting in error, causing noisy and unreliable
connections.
1. Replace the circuit pack.
PASS The TSI is correctly using its allocated time slots.
2 of 2
Issue 5 May 2009 1569