Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
This test runs on SNI-BD (SNI Circuit Pack) and SNI-PEER (SNI Peer Link).
Table 443: Packet Neighbor Link Test (#767) 1 of 5
Error
Code
Test
Result
Description / Recommendation
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 3 times.
2300 ABORT The downlink message necessary to run this test could not be sent.
1. Retry the command at 1-minute intervals up to 3 times.
2301 ABORT The software timer could not be set before sending the downlink message
necessary to run this test.
1. Retry the command at 1-minute intervals up to 3 times.
2302 ABORT Software received incorrect message data from the SNI circuit pack.
1. Retry the command at 1-minute intervals up to 3 times.
2303 ABORT The SNI circuit pack responded that the software test requested is invalid.
1. Retry the command at 1-minute intervals up to 3 times.
2304 ABORT SNI firmware is not able to run the test. For this particular test, the SNI
circuit pack must be able to communicate with its neighbor.
1. Verify that the SNI can communicate with its neighbor by checking
the yellow LED of the SNI to make sure the SNI is in frame, or by
running test board for the SNI and checking test 989 for fiber
out-of-frame. If the results of Test 989 indicate that the fiber is
out-of-frame, follow the recommendation associated with the test
failure. If a DS1 converter complex exists on the fiber link, enter
display errors and follow the repair procedures for any
DS1C-BD and DS1-FAC entries.
2. Retry the command at 1-minute intervals up to 3 times.
1484 Maintenance Alarms for Communication Manager, Media Gateways and Servers
1 of 5