Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 285: NPE Crosstalk Test (#6) 5 of 8
Error
Code
Test
Result
Description / Recommendation
1003 ABORT The system could not allocate a tone receiver for the test. The system may be
oversized for the number of Tone Detectors present, or some Tone Detectors
may be out of service.
1. Enter list measurements tone-receiver to see information
regarding the system’s tone receivers.
2. Resolve any TTR-LEV (TTR Level) errors.
3. Resolve any TONE-PT (Tone Generator) errors.
4. Retry the command at 1-minute intervals up to 5 times.
1004 ABORT The port was seized by a valid call during the test.
DAT-LINE:
1. Enter status data-module extension to determine whether the
port is in use.
2. Retry the command at 1-minute intervals up to 5 times.
PE-BCHL:
1. Enter status pri-endpoint extension to determine the service
state of the port. If the port is in use, wait until it is idle.
2. Retry the command at 1-minute intervals up to 5 times.
WAE-PORT:
1. Enter status access-endpoint extension to determine the
service state of the port. If the port is in use, wait until it is idle.
2. Retry the command at 1-minute intervals up to 5 times.
All other Maintenance Objects:
1. Enter display port location to determine the station extension,
attendant number, or trunk group/member number of the port.
2. Enter status station extension, status attendant
extension, or status trunk extension to determine the service
state of the port. If the port is in use, wait until it is idle before testing.
Attendants are always in use (off-hook) if the handset is plugged in and
the port is not busied out.
3. Retry the command at 1-minute intervals up to 5 times.
1088 Maintenance Alarms for Communication Manager, Media Gateways and Servers
5 of 8