Demand test descriptions and error codes - Avaya Support

Table 323: Sanity Handshake Test (#106) 2 of 2
Error
Code
Test
Result
Description / Recommendation
Sanity Handshake Test (#106)
FAIL No response to the Sanity Handshake.
1. Verify that the carrier A power units are good. If the -5 Volt unit is
defective in the A carrier, communication with the PN’s
Maintenance circuit pack will not be possible.
2. If the -5 Volt unit is good and this test fails continuously, the
system will automatically run the PN’s Maintenance Circuit Pack
Reset test (#306). Otherwise, manually reset a PN’s
Maintenance circuit pack by entering test maintenance
long and evaluate any Error Codes from PN Maintenance
Circuit Pack Reset Test (#306). If Test #306 passes, this test
should also PASS. Use the following steps to determine whether
the PN’s Maintenance circuit pack or its serial link is defective:
Duplicated Port Network Connectivity (PNC):
1. Switch PNC by entering reset pnc interchange.
2. Run the short test sequence against the PN’s Maintenance
circuit pack. If Test #106 still fails, replace the Maintenance
circuit pack and retest. Otherwise, follow the procedures for any
errors that are logged by this test.
Unduplicated PNC:
1. Replace the PN’s Maintenance circuit pack and run the short
test sequence against it.
2. If the error persists, replace the PN Expansion Interface circuit
pack, at a time when the PN can go down with minimal
inconvenience.
3. If the error still persists, the problem is with the actual serial link
in the A carrier backplane and not with the PN’s Maintenance
circuit pack.
PASS The communication path to and from the PN’s Maintenance circuit
pack is sane, and the Maintenance circuit pack can read and report the
correct PN cabinet type. The Maintenance circuit pack may still have
problems related to Tests #228, #229, #303, or #306.
2 of 2
Issue 5 May 2009 1203