Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 402: Board Type Check Test (#574)
Error
Code
Test
Result
Description / Recommendation
1412 ABORT This test does not run on media modules or media gateways. Ignore
2012 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
ANY FAIL Stratum-3 clock synchronization is administered for the carrier where this
Tone-Clock circuit pack resides, but the Tone-Clock does not have board
code TN780.
1. If the Stratum-3 clock option is incorrectly administered, change it.
2. Otherwise, replace the circuit pack. See Replacing the IPSI or
Tone-Clock Circuit Pack.
PASS The proper Tone-Clock circuit pack is present for Stratum-3 clock
synchronization.
Expansion Interface Packet Interface Test (#589)
This test attempts to send a data packet from the TN1655 Packet Interface circuit pack through
any intervening EI circuit packs and/or SNI circuit packs and through the EI circuit pack to be
tested. The path the data packet takes is dependent on the location of the EI circuit pack to be
tested and whether the system has duplicated PNC. The following diagrams and short
discussion of each describe the different paths the test uses.
Figure 102: Expansion Interface Packet Interface Test—Packet Endpoint Loop
PKT-
INT
Packet Bus (PPN) Packet Bus (PN X)
EXP-INTF EXP-INTF
(Optional)
The path shown in Figure 102: Expansion Interface Packet Interface Test—Packet Endpoint
Loop is used when testing a PN EI that is on the active PNC.
1374 Maintenance Alarms for Communication Manager, Media Gateways and Servers
CSS
LAPD
ENDPT