Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 541: Emergency Transfer Query Test (#1532) 1 of 2
Error
Code
1000
2000
1
2
Test
Result
Description and recommendation
ABORT Internal system error.
The response to a query was not received in the time allowed.
1. Repeat the command at one-minute intervals 1 to 3 times.
FAIL The emergency transfer is set to Manual-Off.
The emergency transfer is set to Manual-On.
1. Enter the status cabinet cab or status health cab
command to display the status of the emergency transfer select
switch:
● “on” means that emergency transfer was manually activated by
the set emergency-transfer on command.
● “off” means that emergency transfer was manually deactivated
by the set emergency-transfer off command.
● “auto+” means that the system has a serious alarm that causes
Communication Manager to activate emergency transfer.
● “auto-” means that emergency transfer is not active and is not
being controlled by the set emergency transfer command.
2. If the status is "on" or "off", enter set emergency auto cab
command to return control of emergency transfer to Communication
Manager.
16 FAIL Embedded software (firmware) has activated emergency transfer. This is
an internal error, since Communication Manager should have set the state
to "Manual-on", "Manual-off", or "auto" at the time the TN2312BP was
initiated.
1. Run test maintenance cab to see if communications with the
TN2312BP are up.
2. Reset the TN2312BP circuit pack with reset ipserver.
1688 Maintenance Alarms for Communication Manager, Media Gateways and Servers
1 of 2