Demand test descriptions and error codes - Avaya Support

DS1C Board Options Audit (#795)
DS1C Board Options Audit (#795)
This test sends the administered circuit pack options to the DS1 converter circuit pack. Options
are sent to both DS1 converter circuit packs at the same time to prevent any transitional
mismatch of options.
The following data is sent to the TN574 DS1 converter circuit pack:
● system-reliability configuration
● master and slave endpoints for framing, which is determined by the relative position of the
circuit pack to the server
● facility mask (whether each facility is installed)
● clock reference mask (whether:
- each facility can be used as a clock-reference source
- the board is being used as a network-timing source)
● packet compatible mask (whether each facility is packet compatible)
● facility information for line coding, framing mode, and line compensation
The following data is sent to the TN1654 DS1 converter circuit pack:
● system-reliability configuration
● master and slave endpoints for framing, which is determined by the relative position of the
circuit pack to the server)
● facility mask (whether each facility is installed)
● idle code
● CRC-enabled/-disabled flag (sent in E1 mode only)
● facility information for line coding and line compensation (sent in T1 mode only).
This test runs on the DS1C-BD (DS1 Converter Circuit Pack) maintenance object.
Table 453: DS1C Board Options Audit (#795) 1 of 2
Error
Code
Test
Result
Description / Recommendation
ABORT Could not allocate system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1 of 2
Issue 5 May 2009 1511