Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 286: Conference Circuit Test (#7) 5 of 7
Error
Code
Test
Result
Description / Recommendation
1020 ABORT The test did not run due to either a previously existing error on the
specific port or a more general circuit pack error.
1. Examine the Error Log for existing errors against this port or the
circuit pack and attempt to diagnose and resolve the previously
existing error.
2. Retry the command at 1-minute intervals up to 5 times.
1412 ABORT This test does not run on media modules or media gateways. Ignore.
2000 ABORT Response from the test was not received within the time allowed.
1. Retry the command at 1-minute intervals up to 5 times.
2053 ABORT At least one of the following errors is found on the DS1 circuit pack:
● 1281 – Loss of signal
● 1793 – Blue alarm
● 2049 – Red alarm
● 2305 – Yellow alarm
● 1537 – Hyperactivity
Look for these Error Types in the error log, and follow the procedures
given in the DS1-BD (DS1 Interface Circuit Pack) or UDS1-BD (UDS1
Interface Circuit Pack) maintenance documentation for the listed Error
Types.
2100 ABORT System resources required to run this test are not available.
1. Resolve any TONE-PT (Tone Generator) errors.
2. If there are no TONE-PT errors in the error log, retry the test at
1-minute intervals for a maximum of 5 times.
1096 Maintenance Alarms for Communication Manager, Media Gateways and Servers
5 of 7