Demand test descriptions and error codes - Avaya Support

Link Integrity Inquiry Test (#1282)
Link Integrity Inquiry Test (#1282)
This test checks the link integrity of the TN799 C-LAN Ethernet port’s physical connections. It
runs on ETH-PT (Control LAN Ethernet).
Table 505: Link Integrity Inquiry Test (#1282) 1 of 2
Error
Code
Test
Result
Description / Recommendation
1124 ABORT Ethernet link is not enabled.
1. Verify that the Ethernet link is enabled with status port
location, status link n, or display data-module.
2. If the link is not enabled, enable the link with change
data-module.
3. Repeat the test.
4. Escalate if the problem persists.
1125 ABORT Ethernet link not in service.
1. Verify whether Ethernet link is in service with status port
location or status link n).
2. If the Ethernet link is not in service, release the link with
release link n or release port location.
3. Repeat the test.
4. Escalate if the problem persists.
1959 ABORT Downlink message error.
1. Retry the command at 1-minute intervals, up to 3 times.
2. Escalate if the problem persists.
2012
2100
2500
ABORT Internal system error.
Could not allocate the necessary system resources to run this test.
Internal system error.
1. Retry the command at 1-minute intervals, up to 3 times.
2. Escalate if the problem persists.
1 of 2
Issue 5 May 2009 1625