Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 370: 140AY Chel Sanity Inquiry Test (#222) 2 of 2
Error
Code
Test
Result
Description/ Recommendation
2000 ABORT Response to the test was not received within the time allowed.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
FAIL The test failed. Announcements cot be played back over this port.
1. Reset the circuit pack with reset board location and then
run this test again. If the test continues to fail, replace the circuit
pack (see Warning).
2. If there are recurring alarms on this port caused by this test
failing, replace the circuit pack even if Step 1 works (see
Warning).
WARNING: Replacing
MTP SAT Chel Local Looparound Test (#228)
This test is destructive.
This test checks TN775D on-board circuitry associated with the serial link for the management
terminal connection. This test will not cause the local terminal login to drop, but any data
displayed on the terminal while the test is running will be lost.
The PN’s Maintenance circuit pack has three separate serial interfaces, one for each of the
following:
● Management terminal - tested by Test #228
● Active EI circuit pack - tested by Test #229
● Standby EI circuit pack - tested by Test #229
This test runs on MAINT (PN Maintenance Circuit Pack).
the circuit pack results in loss of integrated
announcements. Refer to General notes.
PASS Announcements can be played back over this port. User-reported
troubles on this pack should be investigated using other port and circuit
pack tests. Refer to -BD (Announcement circuit pack) for a description
of the circuit pack tests.
1304 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 2