Demand test descriptions and error codes - Avaya Support

Table 395: PN Maintenance Circuit Pack Serial Link Test (#337) 2 of 2
Error
Code
Test
Result
Description / Recommendation
Synchronization Update Test (#417)
Synchronization Update Test (#417)
FAIL The serial link between the currently standby EI or standby IPSI circuit
pack and the PN’s Maintenance circuit pack is defective. If the standby
EXP-INTF or IPSI is on Carrier A, then Error Type 3329 is logged. If the
standby EXP-INTF or IPSI is on Carrier B, then Error Type 3585 is
logged.
1. If Error Type 3585 was logged:
● See if the ICCA/ICCB cables between carriers A and B are
present and properly connected (ICCA to ICCA, and ICCB to
ICCB).
This test updates all synchronization parameters for BRI, EI, DS1, ATM Trunk, and Tone/Clock
circuit packs in the system. This test is run for the following maintenance objects:
● ATM-SYNC (ATM Synchronization)
● See if the ICCC/ICCD cables between carriers A and B are
present and properly connected (ICCC to ICCC, and ICCD to
ICCD).
● If the IPSI has faceplate ICC cables See if the faceplate cables
between the IPSIs and Maintenance circuit pack are properly
connected.
2. Install or reconnect the cables if necessary, and rerun the test.
3. Replace the PN’s Maintenance circuit pack.
4. Rerun the test. If the test continues to fail, replace the standby PN
Expansion Interface circuit pack.
5. Rerun the test. If the test continues to fail and the standby link is on
B side, replace the ICC cable or IPSI faceplate cable that carries
the serial link from Expansion Interface or IPSI circuit pack B to the
PN’s Maintenance circuit pack.
PASS The serial link from the standby Expansion Interface or IPSI to the PN’s
Maintenance circuit pack is working.
2 of 2
Issue 5 May 2009 1363