Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 413: BRI Port Local LAN Looparound Test (#618) 1 of 2
Error
Code
Test
Result
Description / Recommendation
1015 ABORT The port is not out-of-service.
1. Enter status bri-port location to determine what stations
or adjuncts are on this port.
2. Enter status station extension to determine whether the
station or adjunct is in use.
3. If the port is in use, wait until it is idle, then busyout the port with
busyout port location to place it in the out-of-service state.
Repeat this test.
WARNING: Since
the “busyout” command is destructive, execution of
this command prior to the port being idle causes every call
associated with BRI endpoints and every transaction
associated with ASAI or Avaya adjuncts on the port to be
torn down. Note that 3 rd -party calls established by an ASAI
or Avaya adjunct remain connected even though the port
is taken out-of-service.
1139 ABORT The packet bus in the port network is out-of-service.
1. Follow the repair procedures for the PKT-BUS (Packet Bus).
2. Enter test port long location and view the results of the
BRI Port Local LAN Looparound Test #618 to verify the repair.
1144 ABORT The Processor Port Network Packet Bus is out-of-service.
1. Follow the repair procedures for the PKT-BUS (Packet Bus).
2. After completing Step 1, enter test port long location, and
view the results of the BRI Port Local LAN Looparound Test #618 to
verify the repair.
1412 ABORT This test does not run on media modules or media gateways. Ignore.
1144 ABRT The PPN’s packet bus is out-of-service.
1. Follow the repair procedures for the packet bus.
2. Issue test port long location and review the results of the
BRI Port Local LAN Looparound test to verify the repair.
1398 Maintenance Alarms for Communication Manager, Media Gateways and Servers
1 of 2