Demand test descriptions and error codes - Avaya Support

This test runs on -BD (Announcement circuit pack).
Table 365: Super Frame Match Inquiry Test (#211)
Error
Code
Test
Result
Description/ Recommendation
Clock Match Inquiry Test (#212)
Clock Match Inquiry Test (#212)
2000 ABORT Response to the test request was not received within the time allowed.
1. Check the Error Log with display errors. If Error Type 1538 is
present in the Error Log for this board, reset the circuit pack.
2. Retry the command at 1-minute intervals up to 5 times.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
ABORT Internal system error.
1. Retry the command at 1-minute intervals a maximum of 5 times.
FAIL Test failed. ouncement playbacks should sound corrupted.
1. Reset the circuit pack via reset board location and then run
this test again. If the test continues to fail, replace the circuit pack
(see Warning).
2. If there are recurring alarms on this circuit pack caused by this test
failing, replace the circuit pack even if Step 1 works (see Warning).
WARNING: Replacing
the circuit pack results in loss of integrated
ouncements. See General notes.
PASS The SP can properly process record/playback requests. User-reported
troubles on this circuit pack should be investigated using other circuit pack
and port tests. Refer to -PT (Announcement Port) for a description of the
port tests.
This test determines the state of the clock generation circuitry on the announcement circuit
pack. This circuitry is used for controlling various pieces of the hardware such as the 140AY
device. It also synchronizes the announcement circuit pack with the clock that is on the
backplane.
This test runs on -BD (Announcement circuit pack).
Issue 5 May 2009 1295