Demand test descriptions and error codes - Avaya Support

Table 534: Network Region Interconnectivity Test (#1417) 1 of 2
Error
Code
1
2
11
Test
Result
Description / Recommendation
Network Region Interconnectivity Test (#1417)
ABORT Internal error
1. Retry the command at 1-minute intervals up to 3 times.
2. If the problem persists, escalate the problem.
1005 ABORT Incorrect test configuration.
1. Verify the Ethernet link is in-service on all C-LAN boards in the
source and destination regions with status port location or
status link n).
1125 ABORT Ethernet link not in service.
1. Verify the Ethernet link is in-service for all C-LAN boards in the
source and destination regions under test using status port
location or status link n. If interface is enabled, the ethernet
link is expected to be in-service for this test to run.
2000 ABORT Response to the test was not received within the allowed time.
1. Retry the command at 1-minute intervals up to 3 times.
2. If the problem persists, reset the circuit pack.
3. Rerun the test. If the problem persists, replace the circuit pack.
2012 ABORT Internal system error.
1. Retry the command at 1-minute intervals, up to 3 times.
2100 ABORT Could not locate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals, up to 5 times.
2500 ABORT Internal system error.
1. Retry the command at 1-minute intervals, up to 3 times.
2801 ABORT No IP address defined.
1. Verify IP interfaces translations and retest.
2802 ABORT Different IP address pinged than was allocated for the test.
1. Retry the command at 1-minute intervals up to 3 times.
2807 ABORT The board is administered but not enabled on the
change ipserver-interfaces screen.
1 of 2
Issue 5 May 2009 1671