Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
ATM Board Time Of Day Update (#1261)
The ATM circuit pack requires a reference time for SDH/SONET performance monitoring. This
test sends the system time to the board to set the time of day. The update synchronizes the
board with the system’s clock. This test runs on ATM-EI (Expansion Interface Circuit Pack),
ATM-TRK (Circuit Emulation Service Circuit Pack).
Table 500: ATM Board Time Of Day Update (#1261)
Error
Code
Test
Result
Description / Recommendation
2031 FAIL The attempt to send the downlink message to the circuit pack failed.
1. Retry the command at 1-minute intervals up to 3 times.
2500 FAIL Internal operation failed.
1. Retry the command at 1-minute intervals up to 3 times.
PASS The circuit pack was successfully updated with the system time.
1. If status port-network still indicates that this link is down, it is
possible that one or both of the ATM circuit packs have been
busied out.
2. If the link still does not come up, reset one or both ATM circuit
packs on the link.
0 NO
BOARD
See NO BOARD for the repair procedures.
SCOTCH Synchronous Looparound Test (#1275)
This test is destructive.
This test verifies the circuit in the data path of a C-LAN PPP call or VAL announcement port call.
This test fails if the data transmitted on the port does not match the data received in the
looparound mode. Failure of this test indicates a port hardware fault on the circuit pack.
This test aborts if calls are using the port, or if the PPP or VAL link associated with the port is
connected. To avoid this, first enter busyout data-module extension, or busyout port
location, or busyout link link#, which will cause every call and link using the port to be
torn down.
1618 Maintenance Alarms for Communication Manager, Media Gateways and Servers