Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 287: GPP NPE Crosstalk Test (#9) 4 of 6
Error
Code
Test
Result
Description / Recommendation
1004 ABORT The port was seized by a valid call during testing.
ADX8D-PT and ADX16D-P:
1. Enter display port location to determine the extension of
the port.
2. Enter status station extension to determine the service
state of the port. If the port is in use, wait until it is idle before
testing.
3. Retry the command at 1-minute intervals up to 5 times.
DIG-LINE and E-DIG-ST:
1. Enter display port location to determine the station
extension or attendant number of the port.
2. Enter status station or status attendant to determine the
service state of the port.
3. If the service state indicates that the port is in use, wait until the
port is idle before retesting. Attendants are always in use
(off-hook) if the handset is plugged in and the port is not busied
out.
4. Retry the command at 1-minute intervals up to 5 times.
M/T-ANL:
1. To determine whether the port is in use by a valid ATMS test call,
enter status station ext where ext is the assigned ATMS
station’s number. If the port is in use, wait until it is idle.
2. Retry the command at 1-minute intervals up to 3 times. If the port
is idle and the test continues to abort, escalate the problem.
M/T-DIG:
1. The port has been seized by a valid ISDN-PRI test call. Enter
list isdnpri-testcall to determine which call is using the
port (from the M/T Port column). Wait for the test call to complete
as indicated in the Start Time and Duration fields of the above
display, or abort the test call with clear isdnpri-testcall
grp#/mem#, where grp#/mem# is determined screen the B-Chel
field list isdnpri-testcall.
2. Retry the command at 1-minute intervals up to 5 times.
1102 Maintenance Alarms for Communication Manager, Media Gateways and Servers
4 of 6